Hi Y'all, Second part to this thread idea... What tools do y'all have? It doesn't matter whether you model steam or diesel, early or late periods. This is not only meant for me but for new guys. What should every tool box have? I'll start by saying.... Good assortment of X-acto knives and blades Good assortment of files Airbrush Painting chalks and India inks. IF YOU HAVE A PARTICULAR BRAND PREFERENCE, PLEASE STATE IT! Thanks y'all! Manny
Bow Compass Circle Template Arch Scale Eng Scale Modeler's Scale Dividers 10-Point Dividers Planimeter Protractor 30-60 Triangles 45-45 Traiangles Corner Clamps Corner Chisel Hemastats NWSL The Chopper Miter Box Razor Saw Pin Vise and Bits NMRA Gauge Multi-Meter Soldering Iron Heat Sinks (clamps) "Blue" Masking Tape Magnifying Visor Sonic Cleaner
There are two additional posts/threads governing some "essentials" for model railroading: Electrical - http://www.frisco.org/vb/showpost.php?p=18315&postcount=1 Adhesives - http://www.frisco.org/vb/showthread.php?t=3618
Thanks guys. I'm not trying to duplicate any threads here on Friscrg. I'm just trying to contribute positively and help stir the pot, get folks excited and bring new blood to the site. Frisco.org is strong already. I just want to make it stronger. I have so much to learn from all of you and I appreciate everyone's help. Please keep up the information. It's invaluable! Thank you! Manny
I will go ahead and add this for you Manny, Screw Drivers, big and small, phillips and flat head. adhesive couplers wheel sets trucks and the tool I use the most is a needle nose plier with built in wire cuter, and I also have a very small needle nose plier.
The underwriter in me is compelled to chime in with a "Safety First" remark. Keep a first aid kit handy and near the toolbox. With good planning and a modicum of caution, it will not be needed, but you will be glad you have it if the need arises. Do not wear shorts at the workbench if you will be using either a soldering iron or an XActo #11 blade. Best Regards,
Yes, I have been there and done that on the shorts with the knife blade and soldering iron. Also, the worst I have EVER been burned was when I used ferrule cement ( the stuff fishermen use to glue the tips on their fishing rods) to fill up a chipped spot in a cork rod handle. I heated the stuff up and missed the spot I was aiming for which spilled the stuff on my right index finger. The glue was so hot it turned my skin white, caused a blister, then my skin turned black and stayed that way until it finally healed. Finally, if you wear eyeglasses don't forget them when your at the workbench. That way if you do have an accident at least you can see it coming! George
I would also like to note that it's not wise to solder on your back with the iron above you as I found out the hard way.
I honestly don't know how people get by without a welder, oxyacetylene torch, metal lathe and milling machine... - James
Ethan, have you considered building models in a slightly larger scale? Sounds like you are pretty much equipped to do it. My track is just a couple of hours down the road from you! - James
Wish I could do the out door 1 foot gauge stuff, but to expensive (HO scale is killing me as it is), and not enough time.
