Direct Radio (Railpro/Ring Engineering)

Discussion in 'Other DCC systems' started by Ozarktraveler, Jun 26, 2021.

  1. Ozarktraveler

    Ozarktraveler Member

    An Introduction to Direct Radio

    Whereas I haven't seen much posted on Direct Radio and I've been grateful for those posting regarding their DCC systems, I'll try to share some of my humble experiences with Direct Radio/Railpro, hereafter referred to as DR or RP.

    Those familiar with DCC systems know that digital commands are sent to locomotives or accessories equipped with decoders via track power from the hand controller (HC, throttle), computer or phone via the command station. Somewhat like a computer network with locomotives and accessories having addresses.

    Traditional DC systems vary voltage to the tracks controlling engine speed. DCC maintains constant voltage and controls engine speed thru digital commands, by controlling the amount of time a locomotive "sees" track power via the decoder reading the digital commands.

    DR places a module in the locomotive or accessory that communicates in real time with the locomotive/accessory. Power is constant like DCC but a command station to encode the digital commands is not utilized.

    Because of this, to speed match you need only run a simple motor current load test (locomotive held stationary while the hand controller (HC) runs a quick test running the motor to 100% throttle and measuring the current load). This information is stored so that when you consist locomotives they talk to the HC in real time comparing the current load of each and adjusting each on the fly.

    Since digital commands are not sent via track power, using the track as a bus, you could run dead rail with an alternative power source, making it similar to RC planes/cars, making it popular with large scale modelers.

    Not a paid spokesman. ..
     
    Last edited: Jun 27, 2021
  2. klrwhizkid

    klrwhizkid Administrator Staff Member Administrator Frisco.org Supporter

    Sirfoldalot, qaprr and Ozarktraveler like this.
  3. pbender

    pbender Member Frisco.org Supporter

    Too big for n-scale unfortunately.

    Paul
     
    Sirfoldalot and Ozarktraveler like this.
  4. Ozarktraveler

    Ozarktraveler Member

    While the manual needs a little updating to catch up with current steps/procedures, one can find the updates on YT, there is Campbell Rice's Railpro group on FB and I think there is another forum someplace.

    One example of changes, you no longer send pictures in for RP to format for the Hand Controller, now you convert your files to bmp files to put custom locomotive pictures onto the Hand Controller.
     

    Attached Files:

  5. Ozarktraveler

    Ozarktraveler Member

    20231121_174848(0).jpg

    Used the box art jpeg files and converted them to bitmap files. Note: they must be 480 x 180 and 24 bit or the Railpro Assistant (RA) software won't accept them. Load them from your computer to RA, from there they can be loaded to the Hand Controller and there they can be accessed by the appropriate locomotive.
     
    WindsorSpring likes this.

Share This Page